3

Having echo >'ed the BSSID of the AP into a file called blacklist, I run the following command to start a deauthentication attack:

mdk3 wlan0mon d -w blacklist -c 11

The problem is however, that every station on every network gets disconnected. This include the desktop I'm sitting at, as well my laptop, even thus they are not connected to the blacklist AP.

What could the problem be - any ideas?

I've no problems with aireplay-ng --deauth, if that should be of any value.

Improve this question

1 Answer 1

Reset to default
1

You can add the mac adresses you want to attack in a blacklist file, and run mdk3 with the -b flag. Since you used the -w flag, it disconnected everyone except the target.

Improve this answer
4
  • Are you sure? Whitelist is for the devices you don't want to attack, right?
    – Shuzheng
    Feb 1, 2016 at 13:02
  • Indeed, I made a mistake.
    – redfast00
    Feb 1, 2016 at 15:29
  • So, I can't use a BSSID? But a BSSID is the MAC address of the access point, right?
    – Shuzheng
    Feb 1, 2016 at 17:05
  • My bad again, I confused ssid and bssid. I edited my answer.
    – redfast00
    Feb 1, 2016 at 17:25

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .